User Tools
3dp:marlin
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3dp:marlin [2026-05-17 Sun 00:53] – theorytoe | 3dp:marlin [2026-06-28 Sun 20:08] (current) – theorytoe | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| ===== Configuring Marlin ===== | ===== Configuring Marlin ===== | ||
| - | The following is a list of steps to take when setting up the configuration for your printer. Generally speaking if you have any calibrated values (i.e. extruder Esteps, hotend/bed PID parameters) you should get the values and then edit the ones in firmware so that your calibrated values are the defaults. There also may be need for post-firmware configuration (such as home offsets and zprobe offsets). The following is a general list of stuff to setup and make sure are present (I would hope the printer you are targeting has most of these features). | + | The following is a list of steps to take when setting up the configuration for your printer. Generally speaking if you have any calibrated values (i.e. extruder Esteps, hotend/bed PID parameters) you should get the values |
| At a baseline, identify the following characteristics of the printer and change the configs to match: | At a baseline, identify the following characteristics of the printer and change the configs to match: | ||
| Line 65: | Line 65: | ||
| * Bilinear vs UBL | * Bilinear vs UBL | ||
| * min 3x3 grid, 2 probes per pt (2nd slowed, grid ideally is 5x5) | * min 3x3 grid, 2 probes per pt (2nd slowed, grid ideally is 5x5) | ||
| + | * set '' | ||
| - Miscellaneous Items | - Miscellaneous Items | ||
| * SD Card Reader Functionality | * SD Card Reader Functionality | ||
3dp/marlin.1778979196.txt.gz · Last modified: by theorytoe
